===== 产品图 =====

{{http://nejetool.oss-us-west-1.aliyuncs.com/wiki/module_3500U/001.jpg?250x250}}
{{http://nejetool.oss-us-west-1.aliyuncs.com/wiki/module_3500U/002.jpg?250x250}}
{{http://nejetool.oss-us-west-1.aliyuncs.com/wiki/module_3500U/003.jpg?250x250}}
{{http://nejetool.oss-us-west-1.aliyuncs.com/wiki/module_3500U/004.jpg?250x250}}
{{http://nejetool.oss-us-west-1.aliyuncs.com/wiki/module_3500U/005.jpg?250x250}}
{{http://nejetool.oss-us-west-1.aliyuncs.com/wiki/module_3500U/006.jpg?250x250}}

===== 描述图 =====


===== 规格 =====

   主要应用：灰度图雕刻，绘图，简单深度雕刻，简单切割等
   接口规格：4pin PH2.0（红：12V，黑：GND，黄：PWM，绿：温度信号）
   波长：405nm
   散热器尺寸：30*60mm
   材质：铜+铝
   重量：121g
   驱动位置:内置
   功率是否可调：可以PWM调节功率
   驱动保护功能：浪涌保护，过压保护
   输入功率：大约12V280ma（包含风扇功率）
   线长：300mm
   控制线安装方式：分体式
   风扇尺寸：30*10mm
   风扇转速：10000转
   可控温度：小于60摄氏度
   聚焦范围：5-50mm
   最佳焦距：距离出光口10mm
   安全警告：请在做好安全防护的前提下应用此模组！
   推荐应用机器：NEJE Master
   包装清单：
   1 x 模组
   2 x 螺丝
   2 x 垫片
   
   
   
  Main applications: grayscale engraving, drawing, simple depth engraving, simple cutting, etc.
  Interface specification: 4pin PH2.0 (red: 12V, black: GND, yellow: PWM, green: temperature signal)
  Wavelength: 405nm
  Radiator size: 30*60mm
  Material: copper + aluminum
  Weight: 121g
  Drive position: built-in
  Is the power adjustable: PWM can be adjusted
  Drive protection: surge protection, overvoltage protection
  Input power: approx. 12V280ma (including fan power)
  Line length: 300mm
  Control line installation method: split type
  Fan size: 30*10mm
  Fan speed: 10,000 rpm
  Controllable temperature: less than 60 degrees Celsius
  Focus range: 5-50mm
  Best focal length: 10mm from the light exit
  Safety Warning: Please apply this module under the premise of safety protection!
  Recommended application machine: NEJE Master
  packing list:
  1 x module
  2 x screw
  2 x gasket