===== 产品图 =====


{{http://nejetool.oss-us-west-1.aliyuncs.com/wiki/module_6000/001.jpg?250x250}}
{{http://nejetool.oss-us-west-1.aliyuncs.com/wiki/module_6000/002.jpg?250x250}}
{{http://nejetool.oss-us-west-1.aliyuncs.com/wiki/module_6000/003.jpg?250x250}}
{{http://nejetool.oss-us-west-1.aliyuncs.com/wiki/module_6000/004.jpg?250x250}}
{{http://nejetool.oss-us-west-1.aliyuncs.com/wiki/module_6000/005.jpg?250x250}}
{{http://nejetool.oss-us-west-1.aliyuncs.com/wiki/module_6000/006.jpg?250x250}}
{{http://nejetool.oss-us-west-1.aliyuncs.com/wiki/module_6000/007.jpg?250x250}}

===== 描述图 =====



===== 规格 =====



  主要应用：深度雕刻，绘图，简单切割等
  接口规格：4pin PH2.0（红：12V，黑：GND，黄：PWM，绿：温度信号）
  散热器尺寸：30*60mm
  波长：450nm
  材质：铜+铝
  重量：128g
  驱动位置:内置
  功率是否可调：可以PWM调节功率
  驱动保护功能：浪涌保护，过压保护
  输入功率：大约12V550ma（不包含风扇功率）
  线长：300mm
  线长材质：运动硅胶
  控制线安装方式：一体式
  风扇尺寸：30*10mm
  风扇转速：10000转
  可控温度：小于60摄氏度
  聚焦范围：10-100mm（最佳焦点：距离出光口50mm）
  安全警告：请在做好安全防护的前提下应用此模组！
  推荐应用机器：NEJE Master
  包装清单：
  1 x 模组
  2 x 螺丝
  2 x 垫片
  


  Main applications: deep engraving, drawing, simple cutting, etc.
  Interface specification: 4pin PH2.0 (red: 12V, black: GND, yellow: PWM, green: 
  temperature signal)
  Radiator size: 30*60mm
  Wavelength: 450nm
  Material: copper + aluminum
  Weight: 128g
  Drive position: built-in
  Is the power adjustable: PWM can be adjusted
  Drive protection: surge protection, overvoltage protection
  Input power: approx. 12V550ma (without fan power)
  Line length: 300mm
  Line length material: sports silicone
  Control line installation method: integrated
  Fan size: 30*10mm
  Fan speed: 10,000 rpm
  Controllable temperature: less than 60 degrees Celsius
  Focus range: 10-100mm (best focus: 50mm from the light exit)
  Safety Warning: Please apply this module under the premise of safety protection!
  Recommended application machine: NEJE Master
  packing list:
  1 x module
  2 x screw
  2 x gasket