主要应用：金属雕刻，深度雕刻，简单切割等
 波长：450nm             
 散热器尺寸：30*60mm
 材质：铜+铝
 重量：116g             
 接口规格：4pin PH2.0（红：12V，黑：GND，黄：PWM，绿：温度信号）
 驱动位置:内置
 功率是否可调：可以PWM调节功率
 驱动保护功能：浪涌保护，过压保护
 输入功率：大约12V750ma 不包含风扇功率             
 线长：300mm
 控制线安装方式：可插式             
 风扇尺寸：30*10mm
 风扇转速：10000转
 可控温度：小于60摄氏度             
 聚焦范围：5-50mm
 最佳焦距：距离出光口10mm             
 安全警告：请在做好安全防护的前提下应用此模组！             
 推荐应用机器：NEJE Master            
 包装清单：
 1 x 模组
 2 x 螺丝
 2 x 垫片
 1 x 控制线

Main applications: metal engraving, deep engraving, simple cutting, etc.
Wavelength: 450nm
Radiator size: 30*60mm
Material: copper + aluminum
Weight: 116g
Interface specification: 4pin PH2.0 (red: 12V, black: GND, yellow: PWM, green: temperature signal)
Drive position: built-in
Is the power adjustable: PWM can be adjusted
Drive protection: surge protection, overvoltage protection
Input power: approx. 12V750ma does not include fan power
Line length: 300mm
Control line installation method: pluggable
Fan size: 30*10mm
Fan speed: 10,000 rpm
Controllable temperature: less than 60 degrees Celsius
Focus range: 5-50mm
Best focal length: 10mm from the light exit
Safety Warning: Please apply this module under the premise of safety protection!
Recommended application machine: NEJE Master
packing list:
1 x module
2 x screw
2 x gasket
1 x control line