Table of Contents

产品图

nejetool.oss-us-west-1.aliyuncs.com_studio_laser-module-405nm-3500_a0.jpg nejetool.oss-us-west-1.aliyuncs.com_studio_laser-module-405nm-3500_a1.jpg nejetool.oss-us-west-1.aliyuncs.com_studio_laser-module-405nm-3500_a2.jpg nejetool.oss-us-west-1.aliyuncs.com_studio_laser-module-405nm-3500_a3.jpg nejetool.oss-us-west-1.aliyuncs.com_studio_laser-module-405nm-3500_a4.jpg nejetool.oss-us-west-1.aliyuncs.com_studio_laser-module-405nm-3500_a5.jpg nejetool.oss-us-west-1.aliyuncs.com_studio_laser-module-405nm-3500_a6.jpg

描述图

nejetool.oss-us-west-1.aliyuncs.com_wiki_master_3500_a4.jpg

规格

 主要应用:灰度图雕刻,绘图,简单深度雕刻,简单切割等
 接口规格:4pin PH2.0(红:12V,黑:GND,黄:PWM,绿:温度信号)
 波长:405nm
 散热器尺寸:30*60mm
 材质:铜+铝
 重量:121g
 驱动位置:内置
 功率是否可调:可以PWM调节功率
 驱动保护功能:浪涌保护,过压保护
 输入功率:大约12V280ma(包含风扇功率)
 线长:300mm
 控制线安装方式:一体式
 风扇尺寸:30*10mm
 风扇转速:10000转
 可控温度:小于60摄氏度
 聚焦范围:10-100mm
 最佳焦距:距离出光口50mm
 安全警告:请在做好安全防护的前提下应用此模组!
 推荐应用机器:NEJE Master
 包装清单:
 1 x 模组
 2 x 螺丝
 2 x 垫片
 
 
 
Main applications: grayscale engraving, drawing, simple depth engraving, simple cutting, etc.
Interface specification: 4pin PH2.0 (red: 12V, black: GND, yellow: PWM, green: temperature signal)
Wavelength: 405nm
Radiator size: 30*60mm
Material: copper + aluminum
Weight: 121g
Drive position: built-in
Is the power adjustable: PWM can be adjusted
Drive protection: surge protection, overvoltage protection
Input power: approx. 12V280ma (including fan power)
Line length: 300mm
Control line installation method: integrated
Fan size: 30*10mm
Fan speed: 10,000 rpm
Controllable temperature: less than 60 degrees Celsius
Focus range: 10-100mm
Best focal length: 50mm from the light exit
Safety Warning: Please apply this module under the premise of safety protection!
Recommended application machine: NEJE Master
packing list:
1 x module
2 x screw
2 x gasket