Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
laser_module_30607w [2019/08/30 17:27]
wuhonghe
laser_module_30607w [2019/08/30 17:58]
wuhonghe
Line 12: Line 12:
 {{http://​nejetool.oss-us-west-1.aliyuncs.com/​wiki/​module_7w/​011.jpg?​250x250}} {{http://​nejetool.oss-us-west-1.aliyuncs.com/​wiki/​module_7w/​011.jpg?​250x250}}
 {{http://​nejetool.oss-us-west-1.aliyuncs.com/​wiki/​module_7w/​012.jpg?​250x250}} {{http://​nejetool.oss-us-west-1.aliyuncs.com/​wiki/​module_7w/​012.jpg?​250x250}}
 +
 +  Main applications:​ deep engraving, simple cutting, ​ aluminum oxide etc.
 +  Wavelength: 450nm
 +  Radiator size: 30*60mm
 +  Material: copper + aluminum
 +  Weight: 116g
 +  Interface specification:​ 4pin PH2.0 (red: 12V, black: GND, yellow: PWM, green: temperature signal)
 +  Drive position: built-in
 +  Is the power adjustable: PWM can be adjusted
 +  Drive protection: surge protection, overvoltage protection
 +  Input power: approx. 12V750ma does not include fan power
 +  Line length: 300mm
 +  Control line installation method: pluggable
 +  Fan size: 30*10mm
 +  Fan speed: 10,000 rpm
 +  Controllable temperature:​ less than 60 degrees Celsius
 +  Focus range: 5-50mm
 +  Best focal length: 10mm from the light exit
 +  Safety Warning: Please apply this module under the premise of safety protection!
 +  Recommended application machine: NEJE Master
 +  packing list:
 +  1 x module
 +  2 x screw
 +  2 x gasket
 +  1 x control line
  • Show page