Table of Contents

产品图

nejetool.oss-us-west-1.aliyuncs.com_wiki_module_20w_001.jpg nejetool.oss-us-west-1.aliyuncs.com_wiki_module_20w_002.jpg nejetool.oss-us-west-1.aliyuncs.com_wiki_module_20w_003.jpg nejetool.oss-us-west-1.aliyuncs.com_wiki_module_20w_004.jpg nejetool.oss-us-west-1.aliyuncs.com_wiki_module_20w_005.jpg nejetool.oss-us-west-1.aliyuncs.com_wiki_module_20w_006.jpg nejetool.oss-us-west-1.aliyuncs.com_wiki_module_20w_007.jpg nejetool.oss-us-west-1.aliyuncs.com_wiki_module_20w_008.jpg nejetool.oss-us-west-1.aliyuncs.com_wiki_module_20w_009.jpg

描述图

规格

主要应用:切割,金属雕刻,绘图深度雕刻等
接口规格:4pin PH2.0(红:12V,黑:GND,黄:PWM,绿:温度信号)
波长:450nm
散热器尺寸:30*80mm
材质:铜+铝
重量:202g
驱动位置:内置
功率是否可调:可以PWM调节功率
驱动保护功能:浪涌保护,过压保护
输入功率:大约12V2A(不包含风扇功率)
线长:300mm
控制线安装方式:可插式
风扇尺寸:30*10mm
风扇转速:15000转
可控温度:小于60摄氏度
聚焦范围:5-50mm
最佳焦距:距离出光口10mm
安全警告:请在做好安全防护的前提下应用此模组!
推荐应用机器:NEJE Master
注意:NEJE Master标配12V2A充电器,如果您是希望升级旧款机器,需要另外准备一个12V3A电源
包装清单:
 1 x 模组
 2 x 螺丝
 2 x 垫片
 1 x 控制线
 

——————————–

Main applications: cutting, metal engraving, drawing depth engraving, etc.
Interface specification: 4pin PH2.0 (red: 12V, black: GND, yellow: PWM, green: temperature signal)
Wavelength: 450nm
Radiator size: 30*80mm
Material: copper + aluminum
Weight: 202g
Drive position: built-in
Is the power adjustable: PWM can be adjusted
Drive protection: surge protection, overvoltage protection
Input power: approx. 12V2A (without fan power)
Line length: 300mm
Control line installation method: pluggable
Fan size: 30*10mm
Fan speed: 15000 rpm
Controllable temperature: less than 60 degrees Celsius
Focus range: 5-50mm
Best focal length: 10mm from the light exit
Safety Warning: Please apply this module under the premise of safety protection!
Recommended application machine: NEJE Master
Note: NEJE Master comes standard with 12V2A charger. If you want to upgrade your 
old machine, you need to prepare another 12V3A power supply.
packing list:
1 x module
2 x screw
2 x gasket
1 x control line
  • Show pagesource