This is an old revision of the document!

主要应用：深度雕刻，绘图，简单切割等
接口规格：4pin PH2.0（红：12V，黑：GND，黄：PWM，绿：温度信号）
散热器尺寸：30*60mm
波长：450nm
材质：铜+铝
重量：128g
驱动位置:内置
功率是否可调：可以PWM调节功率
驱动保护功能：浪涌保护，过压保护
输入功率：大约12V550ma（不包含风扇功率）
线长：300mm
线长材质：运动硅胶
控制线安装方式：一体式
风扇尺寸：30*10mm
风扇转速：10000转
可控温度：小于60摄氏度
聚焦范围：10-100mm（最佳焦点：距离出光口50mm）
安全警告：请在做好安全防护的前提下应用此模组！
推荐应用机器：NEJE Master
包装清单：
1 x 模组
2 x 螺丝
2 x 垫片

Main applications: deep engraving, drawing, simple cutting, etc.
Interface specification: 4pin PH2.0 (red: 12V, black: GND, yellow: PWM, green: 
temperature signal)
Radiator size: 30*60mm
Wavelength: 450nm
Material: copper + aluminum
Weight: 128g
Drive position: built-in
Is the power adjustable: PWM can be adjusted
Drive protection: surge protection, overvoltage protection
Input power: approx. 12V550ma (without fan power)
Line length: 300mm
Line length material: sports silicone
Control line installation method: integrated
Fan size: 30*10mm
Fan speed: 10,000 rpm
Controllable temperature: less than 60 degrees Celsius
Focus range: 10-100mm (best focus: 50mm from the light exit)
Safety Warning: Please apply this module under the premise of safety protection!
Recommended application machine: NEJE Master
packing list:
1 x module
2 x screw
2 x gasket