Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
ro:laser_module_450nm_20wu [2019/06/16 23:07] wuhonghe |
ro:laser_module_450nm_20wu [2019/06/16 23:18] wuhonghe |
||
|---|---|---|---|
| Line 34: | Line 34: | ||
| 2 x 垫片 | 2 x 垫片 | ||
| 1 x 控制线 | 1 x 控制线 | ||
| + | |||
| + | -------------------------------- | ||
| + | |||
| + | Main applications: cutting, metal engraving, drawing depth engraving, etc. | ||
| + | Interface specification: 4pin PH2.0 (red: 12V, black: GND, yellow: PWM, green: temperature signal) | ||
| + | Wavelength: 450nm | ||
| + | Radiator size: 30*80mm | ||
| + | Material: copper + aluminum | ||
| + | Weight: 202g | ||
| + | Drive position: built-in | ||
| + | Is the power adjustable: PWM can be adjusted | ||
| + | Drive protection: surge protection, overvoltage protection | ||
| + | Input power: approx. 12V2A (without fan power) | ||
| + | Line length: 300mm | ||
| + | Control line installation method: pluggable | ||
| + | Fan size: 30*10mm | ||
| + | Fan speed: 15000 rpm | ||
| + | Controllable temperature: less than 60 degrees Celsius | ||
| + | Focus range: 5-50mm | ||
| + | Best focal length: 10mm from the light exit | ||
| + | Safety Warning: Please apply this module under the premise of safety protection! | ||
| + | Recommended application machine: NEJE Master | ||
| + | Note: NEJE Master comes standard with 12V2A charger. If you want to upgrade your | ||
| + | old machine, you need to prepare another 12V3A power supply. | ||
| + | packing list: | ||
| + | 1 x module | ||
| + | 2 x screw | ||
| + | 2 x gasket | ||
| + | 1 x control line | ||