Differences

This shows you the differences between two versions of the page.

--- ro:laser_module_450nm_7wu [2019/06/16 23:16]
wuhonghe
+++ ro:laser_module_450nm_7wu [2019/06/16 23:21]
wuhonghe
@@ Line 13: / Line 13: @@
    主要应用：金属雕刻，深度雕刻，简单切割等
    波长：450nm
    散热器尺寸：30*60mm
    材质：铜+铝
    重量：116g
    接口规格：4pin PH2.0（红：12V，黑：GND，黄：PWM，绿：温度信号）
    驱动位置:内置
    功率是否可调：可以PWM调节功率
    驱动保护功能：浪涌保护，过压保护
    输入功率：大约12V750ma 不包含风扇功率
    线长：300mm
    控制线安装方式：可插式
    风扇尺寸：30*10mm
    风扇转速：10000转
    可控温度：小于60摄氏度
    聚焦范围：5-50mm
    最佳焦距：距离出光口10mm
+   安全警告：请在做好安全防护的前提下应用此模组！
-   安全警告：请在做好安全防护的前提下应用此模组！
+   推荐应用机器：NEJE Master
-   推荐应用机器：NEJE Master
    包装清单：
 x 模组
@@ Line 45: / Line 37: @@
 x 控制线
+-----------------------
+  Main applications: metal engraving, deep engraving, simple cutting, etc.
+  Wavelength: 450nm
+  Radiator size: 30*60mm
+  Material: copper + aluminum
+  Weight: 116g
+  Interface specification: 4pin PH2.0 (red: 12V, black: GND, yellow: PWM, green: temperature signal)
+  Drive position: built-in
+  Is the power adjustable: PWM can be adjusted
+  Drive protection: surge protection, overvoltage protection
+  Input power: approx. 12V750ma does not include fan power
+  Line length: 300mm
+  Control line installation method: pluggable
+  Fan size: 30*10mm
+  Fan speed: 10,000 rpm
+  Controllable temperature: less than 60 degrees Celsius
+  Focus range: 5-50mm
+  Best focal length: 10mm from the light exit
+  Safety Warning: Please apply this module under the premise of safety protection!
+  Recommended application machine: NEJE Master
+  packing list:
+x module
+x screw
+x gasket
+x control line

Show page